public:radio:allstar:allstar_nodes_built
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
public:radio:allstar:allstar_nodes_built [11/06/25 08:00 BST] – [VHF Gateway] john | public:radio:allstar:allstar_nodes_built [19/06/25 10:19 BST] (current) – [DMR Bridging Node] john | ||
---|---|---|---|
Line 8: | Line 8: | ||
|Platform| Raspberry Pi 2 Model B Rev 1.1 | | |Platform| Raspberry Pi 2 Model B Rev 1.1 | | ||
+ | |OS| Raspbian GNU/Linux 10 (buster) | | ||
+ | |ASL Version | 2.0.0-beta.6 | | ||
|Interface|CM108 Soundcard - modified| | |Interface|CM108 Soundcard - modified| | ||
|Radio|FT-1500M @ 5W| | |Radio|FT-1500M @ 5W| | ||
- | |Frequency|144.900MHz| | + | |Frequency|144.9125MHz / CTCSS : 77.0Hz| |
|Allstar Node | [[http:// | |Allstar Node | [[http:// | ||
|Echolink | GM4SLV-L : 886089 | | |Echolink | GM4SLV-L : 886089 | | ||
- | |Dashboard| http:// | + | |Dashboard| |
The initial node, described here -> [[gm4slv_allstar_2025|]] got too cumbersome after adding DMR Bridging, along with handling Echolink. | The initial node, described here -> [[gm4slv_allstar_2025|]] got too cumbersome after adding DMR Bridging, along with handling Echolink. | ||
Line 21: | Line 23: | ||
I removed the DVSwitch bridging from the VHF Gateway node and changed its node ID to '' | I removed the DVSwitch bridging from the VHF Gateway node and changed its node ID to '' | ||
- | < | ||
- | Wed 11th June 2025 | ||
- | |||
- | Disabled Echolink on this node, and re-enabled it on [[test_node|]] instead. | ||
- | |||
- | </ | ||
Line 90: | Line 86: | ||
===== DMR Bridging Node ===== | ===== DMR Bridging Node ===== | ||
- | |Platform | Raspberry Pi 3 Model B Rev 1.2 | | + | |Platform | Raspberry Pi 4 Model B Rev 1.5 | |
+ | |OS |Debian GNU/Linux 12 (bookworm) | | ||
+ | |ASL Version |3.7.1-1.deb | ||
|Allstar Node | [[http:// | |Allstar Node | [[http:// | ||
|Dashboard| http:// | |Dashboard| http:// | ||
+ | |||
+ | < | ||
+ | New hardware and OS install | ||
+ | |||
+ | Installed OS first Pi OS 64 bit Lite -> | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | then the ASL repository and finally ASL3 and Allmon3 following guide at: | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | I found this much nicer than the "Pi Appliance" | ||
+ | |||
+ | </ | ||
This one is for running DVSwitch to bridge to (at the moment) TGIF TG23544< | This one is for running DVSwitch to bridge to (at the moment) TGIF TG23544< | ||
- | I added the DVSwitch software, in the same way described here [[gm4slv_allstar_2025|]] and decided to bridge to '' | + | I added the DVSwitch software, in the same way described here [[gm4slv_allstar_2025|]] |
public/radio/allstar/allstar_nodes_built.1749625201.txt.gz · Last modified: by john