Differences

This shows you the differences between two versions of the page.

--- public:radio:2024:allstar [08/04/24 00:26 BST] – [Section Two] john
+++ public:radio:2024:allstar [06/03/25 06:49 GMT] (current) – external edit 127.0.0.1
@@ Line 15: / Line 15: @@
 |Radio|FT-8900|
 |Frequency|144.9125 MHz|
-|Monitor|[[http://gm4slv.plus.com:42111/allmon2/link.php?nodes=48148|Allmon2]]|
+|Monitor|[[http://gm4slv.plus.com:42111/supermon/link.php?nodes=48148|Supermon]]|
 |AllStar | [[http://stats.allstarlink.org/stats/48148]]|
@@ Line 55: / Line 55: @@
 Reboot again, and now I can SSH via the correct static IP address
-Next Steps
+==== Next Steps ====
-  * Add my own user (don't want to use the built in ''repeater'' user
+  * Add my own user (don't want to use the built in ''repeater'' user)
   * Add myself to the necessary groups (sudo etc.)
+  * change the hostname from ''repeater'' -> ''asterisk''
+    * remember to edit ''/etc/hosts'' as well as ''/etc/hostname''
+  * set timezone to ''Europe/London''
   * Check the RX/TX levels/deviation with ''/usr/sbin/simpleusb-tune-menu '' - the levels were spot on due to using the same setup, and the same config. files as the previous incarnation.
   * Enable Echolink by editing ''/etc/asterisk/modules.conf'' to load the Echolink Module (last time I'd disabled it)
   * Copy any necessary ''allmon2'' files to ''/var/www/html/allmon2/''  & set up ''allmon2''
   * Port Forward on router:
-    * UDP/4569
+    * ''UDP/4569''
-    * UDP/5198
+    * ''UDP/5198''
-    * UDP/5199
+    * ''UDP/5199''
   * All working...!
-=== First QSO ===
+==== First QSO ====
  * I was called on Echolink by ''G0RAS'' while I was out walking the dogs. We had a good chat, so that was a good test that it's all working
@@ Line 80: / Line 83: @@
   * <key>*</key><key>5</key><key>3</key><key>1</key>
-<code>
+<code bash>
 [macro]